Introduction: Developed for the Guardian model that simulates the engine
with the front motor,the unique engine compartment bracket design increases
the fixing of the car shell bracket to the original car shell pillar, and uses t
he R button to fix the car shell (to ensure the stability of the rollover car shell),
Built-in under the cover, so that the cover part of the car shell can be
independently cut to open and close.
The simulated water tank bracket has a built-in magnet, which can be cut and closed invisibly.
For: TRX-4 Defender
G.w.: 85g

Product Parts List:
D8X6 magnet*2 pcs
D12X4 magnet*2 pcs
M3X6 round head*12 pcs
1:10 R clip*2 pcs
M3X8 screws*2 pcs
Hinge 10X8mm*2 pcs
M1.6X6 screws *8 pcs
M1. 6 nuts * 8 pcs

Shows on TRX-4 Defender

Kit installation instructions:
To use this kit, you need to cut the hood of the car shell.
It is recommended to evaluate the actual DIY ability before purchasing.

4. Remove the front fender connector (#8019),
and replace the corresponding metal connector in the kit:

The effect of the replacement is as shown below:

5. Install 2 built-in magnets:

Tips:
A exposed Body mout base is installed on the frame.
Note that this modification is only compatible with the GRC Aluminum Body mount !#GAX0120FA/FB

7.Final assembly:

If using screws to fix the car shell:

This is a modified kit for RC geek, thank you for reading!